Headlights For 2004-2008 Ford F-150 Pickup Black Housing Amber Corner Pair

Description

Specifications:

 

Made of materials that meet or exceed OEM requirementsHigh/Low Beam Bulb Type: H13(Bulbs are not included, need to reuse original bulbs)Turn Signal Light Bulb Type: 3157A/W5W(Bulb are included)

 

Features:

 

Completely sealed: Prevents moisture from being trapped inside the housing

One-way vent: Drives out moisture and avoids lens misting

Multi-surface reflectors: Increase light output & distance

PC lens: Impact resistance for an enhanced driving experience in any environment

 

Fitment:

 

For 2004-2008 Ford F-150

For 2006-2008 Lincoln Mark LT

NOT Compatible with 2004 F150 Heritage

NOT Compatible with Flareside Beds Models

PART NUMBER: 3221-2005L / 3221-2005R

HOLLANDER: 114-00784AL / 114-00783AR

OE#: 7L3Z 13008 GA / 7L3Z 13008 FA

 

PARTSLINK: FO2502201 / FO2503201

 

Package Includes:

 

Pair LH(Left Hand)&RH(Right Hand) Headlight Assembly 

 

Installation:

 

1). How to install:

1. Undo the screws, clips, or retainer springs that hold the headlight in place.

2. Disconnect the wiring from the assembly.

3. Detach the headlight from the vehicle to replace it with a new one.

4. Fit in the new headlight assembly.

5. Fix the new headlight into place and make sure that the screws, clips, or retainer springs used are sealed.

6. Reconnect the wiring that was unplugged from the assembly.

7. Put back the grille and other components that you removed. Seal them back into place.

8. Test the new assembly.

 

2). How to adjust:

Before you begin to adjust the light, make sure to check the alignment of your lights first. Park the vehicle about 10 to 25 feet from the wall with the lights aimed at the wall. The centerlines of the headlights should not be any higher than 3.5 feet above the ground.

 

1. Find the adjustment screws.Firstly, locate the adjustment screws on your vehicle.

2. Adjust the headlights individually. The headlights should be adjusted one at a time. Put a rag or towel over a chair in front of the light you want to block. Covering the light assembly directly can damage the plastic lens.

3. Adjust the vertical field. The screw on the top of the light housing should be turned clockwise to raise the lights and counterclockwise will lower the light. The headlight should be adjusted until the top of the most intense part of the light beam shines directly on or just below the center of the tape line on the wall.

 

4. Test your results.